- [Compatibility] - Works on Detroit Series 60 engine.
- [Replace Part Number] - Alternative to J-46904 J-48824. Use J-46904 for screw-in stainless cups 240-1039 23538840 240-1035 23533148. Use J-48824 for screw-in stainless cups 240-1045 23534745 23538829.
- [Functions] - Works on screw-in stainless steel cups to remove or install the injector cups. Properly set injector body height to the injector follower for proper fuel injector timing. Incorrect injector timing can cause engine power issues, poor idle quality and fuel mileage issues, significantly saving your time and energy.
- [High Quality] - Advanced blackening hard steel process, durability and anti-corrosion. Ultra-precise design meets the requirement of high precision and hardness and a much longer service life.
- [What will you get] - We offer 2-years shelf life, hassle-free return and money back policy, buy with confidence! You will get J-46904 J-48824 injector sleeve removal installer tool
For Detroit Diesel 60 Series Injector Cup Remover Installer Tool
Fitment
For Detroit Diesel 60 Series, alternative to J-46904 & J-48824.
--Use J-46904 for screw-in stainless cups 240-1039 23538840 240-1035 23533148.
--Use J-48824 for screw-in stainless cups 240-1045 23534745 23538829.
Features
- Function: Alternative to J-46904 & J-48824 to work in an easier way to save your time and money.
--Meterial: Advanced blackening solid steel process, durability and anti-corrosion. Ultra-precise design meets the requirement of high precision and hardness and a much longer service life.
--Works on screw-in stainless steel cups to remove or install the injector cups.
Using Instruction:
1. Install injector tube service tool (J-46904 or J–48824, ) into injector tube.
Ensure tabs are engaged in tube and tool is completely seated.
2. Turn tool counterclockwise to remove the injector tube from the cylinder head.
Observe and record locations of any shims installed under the injector sleeve.
3. If using J-48824 to remove the injector tube, turn the center bolt to expand the fingers located on the end of the tool.
NOTE: When the injector tube is removed, check the bottom of the tube and tube bore to see if a shim has been installed.
If a shim is installed on the removed injector tube and the tube is being replaced, the new tube will also need a shim.
The shim is used to adjust the height of the injector cup after the cylinder head has been resurfaced
Package Included
1× J-46904 Nozzle/ Cup/ Sleeve/ Tube Remover Installers
1× J-48824 Nozzle/ Cup/ Sleeve/ Tube Remover Installers
